The Belkin N300 F9K1010 v2 was launched in 2015 and is a N300 class router.
|N300 F9K1010 v2|
Mobile networks are not supported.
The router has built-in VPN support. VPN support allows you to pass all of your internet traffic through a VPN service. Depending on the service, this could hide your location, encrypt your data, and better protect your devices against security threats.
The coverage is supported by 2 x 3 dBi fixed antennas. Whilst antennas may assist in range, additional antennas tend to help more with ensuring devices can simultaneously connect to the router. They can help avoid interference, along with helping increase signal strength to devices within the usable range.
The Wifi standards offered are IEEE 802.11b/g/n and they're offering connection speeds of 300 Mbps.
Security protocols offered by the Belkin N300 F9K1010 v2 are WEP WPA WPA2 WPS.
|2 x 3 dBi fixed|
|WEP WPA WPA2 WPS|
It's powered by a Realtek RTL8196E @ 400 MHz processor, and contains 32 MB of ram.
The power supply is a 12 V / 0.5 A power supply.
So if you're looking for a 12v router, this might the one!
The router supports the IPv4 IPv6 protocols.
|Realtek RTL8196E @ 400 MHz|
|12 V / 0.5 A|
You're looking at 4 x 10/100 Mbps LAN (local area network) connection ports, with 1 x 10/100 Mbps WAN (wide area network) ports available.
|4 x 10/100 Mbps|
|1 x 10/100 Mbps|
The Default IP to login to the admin area of the Belkin N300 F9K1010 v2 is 192.168.2.1.
You can log in to the router by using the username "[blank]" and the password of "[blank]" provided it hasn't been changed.